Page 1 of 1

Slammer tool

Posted: Thu Aug 15, 2019 4:55 am
by Gerryo619
Does anyone own a slammer tool? I think I might invest but seems to be out of stock everywhere in the US. Wondering if anyone has any insight on tool in general.


Sent from my iPhone using Tapatalk

Re: Slammer tool

Posted: Fri Aug 16, 2019 7:52 pm
by dependable
These guys have one. Kind of pricey though.

http://bamboogarden.com/Tools.htm

I don't own one, but remember a thread here years ago. Some people liked them, but still a lot of work. One could make one or have one made by a local welder too. Be careful where you put your hands with any slide hammer tool. I know this from mechanicing.

What I use to cut small divisions is a sawzall with long demo blade. Big divisions I use a chain trencher and loader with pallet forks. If you have a lot to do, suggest you hire same.