It is currently Wed Oct 16, 2019 7:02 am

All times are UTC

Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Slammer tool
PostPosted: Thu Aug 15, 2019 4:55 am 

Joined: Fri Oct 24, 2014 4:41 am
Posts: 75
Location: San Diego CA
Does anyone own a slammer tool? I think I might invest but seems to be out of stock everywhere in the US. Wondering if anyone has any insight on tool in general.

Sent from my iPhone using Tapatalk

 Post subject: Re: Slammer tool
PostPosted: Fri Aug 16, 2019 7:52 pm 

Joined: Mon Nov 03, 2008 12:28 am
Posts: 1216
Location: Island off Cape Cod Massacusetts
These guys have one. Kind of pricey though.

I don't own one, but remember a thread here years ago. Some people liked them, but still a lot of work. One could make one or have one made by a local welder too. Be careful where you put your hands with any slide hammer tool. I know this from mechanicing.

What I use to cut small divisions is a sawzall with long demo blade. Big divisions I use a chain trencher and loader with pallet forks. If you have a lot to do, suggest you hire same.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group